VERO DESIGN GALA Instructions d'exploitation télécharger pdf (Page 35)

Instal. GAL

35 / 40

Installation instructions Operating instructions

Problems and solutions

General

After the appliance is lit, there’s an odor coming from the appliance

When first operated, the appliance may release an odor. This is caused by the curing

of the paint. This is a normal result! Ventilate the room thoroughly.

The air grilles (on top) draw air

The grilles, warm / cold air, are not connected to the fireplace.

Contact your professional dealer and have the grilles connected or close / cover the

connection pieces.

The stucco on the wall shows bursts on the frontside

The appliance has not been properly covered with insulation or not insulated at all.

The consequences are that there is heat transfer to the other materials. Contact your

professional dealer.

A black, rusty dust is forming against the warm air grilles

The cold air grilles absorb small dust parts. Because of the air warming up, the dust

parts warm up as well and mingle with the warm air which leaves through the air grilles.

Then the dust parts cool off and settle on the appliance. Dust the grilles as often as

possible with a duster and use a vacuumcleaner.

The corners on the frontside of the fireplace are damaged

The brickwork or stucco has been done too close to the fireplace. Contact your.

professional dealer.

Dirt is falling into your fireplace

Have your flue swept by a professional chimney-sweeper.

By using propane gas, a black fumagine layer may occur.

The glass (ceramic) is damaged

Swith off the fireplace immediately! Never lite the fireplace with damage on the glass!

Make sure you order a new glass with your professional dealer.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40

Pas de commentaire

VERO DESIGN GALA Instructions d'exploitation Page 35